Setting up a wireless network are not a thing of mystery, like everything else, this implies a number of directions on how to do it. Even if you are not too technical, you need not worry, my 13 year old son followed these steps to set up a wireless network and was able to use laptop in his room after 10 minutes. If he, if you can can do it.
Even if you do not have an IP pattern of attack, it may be worth it. Just keep in mind that the IP addresses, the first numbers affect the largest number of computers as a reverse address: USA, California, Sacramento, X Building, Ste. 101 Joe Schmo. An IP roughly follows the same pattern, wherein the last of the four sections, which it is attached to the specific computer.
Many routers are easier to set up with newer formats, often with the software on a CD, which will guide you through the process. Anyway, you want to refer to the instructions that come with each router. Here are the normal stages that come with setting up a router.
Once to keep you flashed the DD-WRT firmware on your last repeater router, it helps you to reach the browser (especially 192.168.1.1). Configure the selection of the IP address to make sure one thing that is the same subnet. For example intended when the big router comes with an IP address of 192.168.1.1 to configure the last repeater that 192.168.2.1 with the same subnet as the primary router (v. 255.255.255.zero). Create positive that DHCP is enabled at this point.
Who needs to know the name of your wireless network? You do, of course. And everyone else that you want to access your wireless network. But your neighbor to know? Or the type of the drive from your home? Of course not. There is an option to disable SSID broadcast. Again, look at the documentation for your router, as you make this change (or someone you trust). Well, nobody can your SSID from the list of “Network connections.”
The router, which is the Internet connection will the unique configuration and properties are likely wanted to use in writing to the repeater router. To simplify network configuration, create sure that the security of wireless access is prepared to use “None” and the Wi-Fi Channel, is about a certain number (6, 9 or 11). By adding these two parameters, you change the Wi-Fi system G. For now, with regard to the fact that your network is open worry, you can quickly reconfigure it as you are sure that the repeater work safely. Write down the SSID on this point.
The next part will not be carried in your browser. Enter one of the following addresses in your browser. The likely included in the instructions for your router, but usually it 192.168.1.1, 192.168.2.1 or 192.168.0.1 be. You should be able to do this without being able Internet.
Cable: – Depending on the size of the network and to use, you can choose the category of cable. For a small network, you can use a CAT5 cable, the use 10x / 100Mbps support. However, you have the option of also buying Cat 6 cable supports speeds of up to 1Gbps. Here I am going to use CAT5 cable.
Save your changes and exit. Then pull the connected network cable from the computer to the router and plug the adapter in place.
The following steps show how easy it is to tasks for which you otherwise seek support Netgear router perform. The above steps are valid not only for Netgear router, but the router Belkin, Linksys Router and D-Link router. This means you can now walk with the support of Linksys, Belkin support and support D-Link, you save time and your precious money.